Recent content by jeckel7234

  1. J

    Band Brake Rod?

    awesome thanks you fellas
  2. J

    Band Brake Rod?

    I should be able to bend that with a vice and propane torch right?
  3. J

    Band Brake Rod?

    I was planning on building my first kart but i found a good deal on craigslist for a kart that was a little tight for my 6' 2" frame. i extended the kart 8 1/2" ive got everything hooked back up how it needs to be except for the band brake, before there was aluminum round bar that was connected...
  4. J

    Clutch doesnt have set screw????

    :surrender: alright good enough ill just go get a new one i guess
  5. J

    Clutch doesnt have set screw????

    and in the second picture the crack, is that going to cause any big problem it doesnt seem to of made anything loose
  6. J

    Clutch doesnt have set screw????

    I dont see anywhere that looks like a snap ring would go heres some pictures front and back of both pies and down the shaft hole
  7. J

    Clutch doesnt have set screw????

    yea sorry i did put that in the original post i tried that, the part of the clutch with the teeth for the chain stays put for the most part but the part of the clutch that expands out slides all the way toward the engine leaving about 1/4" that would contact the walls of the other piece. Is a...
  8. J

    Clutch doesnt have set screw????

    Ive got a centrifugal clutch im trying to put on my hf 212cc motor, the clutch doesnt have set screws or any other type of screw or hole that would look like it mounts to the shaft? So how do i mount it thanks
  9. J

    New guy with some Q'

    what exactly are you referring to about the bore and how will a sprocket keyed for different bore sizes be a benefit? Thanks
  10. J

    New guy with some Q'

    the smallest sprocket i could find as a 40 tooth and using the speed calc on this forum it seems like im going to be hard pressed to get faster then 8mph, even with that plugging in a 30 tooth bumped it up to 13mph which still wont do i was still wating to get around 30 mph and i can govern it...
  11. J

    New guy with some Q'

    im looking at what size to for with the sprocket and clutch, Northerns website says its max RPM is 3600, so with the gear reduction at 6:1 its really at 600 RPM correct even though the website giving those specs were off of the motor with the gear reduction box
  12. J

    New guy with some Q'

    yea ive considered it but i dont have a bender or a decent way to notch all the tubing so i figyure for my first cart ill be better off with square tubing
  13. J

    New guy with some Q'

    i will, im planning on using 1 1/4" square tubing for most of the frame and roll cage if i do it, but what size sheet do most people use for the floor
  14. J

    New guy with some Q'

    yea were on the same page, and again thank you for the info. ive started drawing it up and gonna start fab later this week
  15. J

    New guy with some Q'

    yes i believe so because there is a smaller amount or surface area for the chain on the centrifugal clutch than the sprocket it causes the sprocket to turn faster. And depending on that relationship decides the ratio and the acceleration/top speed trade off
Top