Recent content by gabe1318

depending on your size and weight to should get between 3-5hp and the compression can be felt when you pull the starter cord, if you pull it slow you should fell when the piston hit top dead center or so( it will provide resistence). you want and need compression on an engine its the engines...

i have a 7 inch face, what size did you need?

could have been moisture in the fuel

there is only enough shaft on the hub to fit one bearing but here are some pis for illustration, also the swingarm is gonna be a steel plate 26x4x1/2 that the bearing will mount to

Im modding an x1 pocket bike with honda civic spare tires and rims to give it a bigger stance im stretching the front and rear and well i have a honda civic hub which has a 1.5inch shaft so i have a 1.5 inch pillow block bearing but its self aligning so it wont hold straight. is there a mod to...

these guys are only trying to help, i think a good ratio for you is 6 to 1, i think your running #40 chain so a 60 tooth sprocket on the rear should do it, if your tire diameter is smaller than the sprocket your not gonna be able to ride so your diameter matters

in order for you to find out what hub you need you first need to know the bolt pattern from that wheel, once you know the bolt battern you can find a hub that bolts to your wheel and goes on shaft usually 1inch but i have seen 3/4 ones, there are hubs available that you can bolt on a sprocket...

Looks like #35 chain and sprocket, as far as the length of chain you need you can measure once you have a clutch in place using a string or similar

My name is Gabe and I'm new to the forum, this is my first post so here it is. I'm building a mini chopper on the cheap and homemade but i have access to lots of metal and drives so I don't have to sacrifice much so what types of drives are there other than torque converters, pulley and...