Recent content by Diesel_mech85

Liking your gold monaro in background or gto as u call em over there.

Try getting some little rose joint / heim joints with hole right through. Then with bolt on top or even add a washer and it shouldn't come off. Even a normal Clevis would work. May e try putting yours together and giving it squeeze/ tap with a hammer each side or put it in a vice to tighten...

Looking at your steering? Is your tierods on pitman arm/ link off your steering shaft one mounted lower than another? Do you find your kart turns ones way better than the other as it would be pushing/ pulling one side more than the other hence wheel turning more than other shorter side

I'm in the process of sizing up bearings to replace the bronze bushes in the front wheel of an old AMF mower. Idea is that they should press in tight to bore of wheel have a sleeve in between the bearings so it can be tightened up and with either 14, 16mm Id. Or 1/2" 9/16" so I can just use a...

ok so im trying to put some pictures up pretty much its the basic frame shape with our stolen office chair we took from a meeting room, steering wheel with the plastic /poly stuff boss to suit our steering shaft, the lawn mower wheel donor and the steering king pin/knuckle without stubs...

Hi all. Been reading this site a couple of weeks now gathering information and ideas to start a build of a go kart/ buggy. So far we have bent up a couple of bite of tube to make a simple kart design, made the front spindles, SaaS steering wheel custom boss to fit, Honda gx270 9hp elec start...