Recent content by conconinc

  1. C

    changing to torque converter

    Thank you I will start with original and go from there. I traded this machine for some money a guy owed me and have replaced about three clutches. I think this will work and having the parts manual will help out a lot thanks for your help. Once I get everything installed will let you know how...
  2. C

    changing to torque converter

    Clutch is 10 teeth Jack shaft from the clutch is 23 teeth Jack shaft to the axle 12 teeth Axle 17 teeth 140/70 x 6" tires I am sure you are right but don't know how to get it right without guessing and the gears are to expensive to be guessing. Mostly just the grand kids are driving it up...
  3. C

    need urgent feedback

    Do you have room to drill a couple of set screws or maybe a hole through both clutch and crank and install a roll pin
  4. C

    changing to torque converter

    Hi Guys I have a Manco Eliminator 435b that is a single wheel drive and seems like I am always changing the centrifigual clutch can you tell me if it would be better with a torque converter? I was told by someone else that if it was single wheel drive it wouldnt make much difference. I have a...
Top