Recent content by buffaloglenn

  1. B

    B&S 3 HP 5/8" Shaft adapter

    Does anyone make an adapter to go from the 5/8" shafts to a 3/4" width shaft so that you can then use a comet 30 torque converter? I have access to a few of these and have a good TC I would like to use. It seems like there would be something available to do this.
  2. B

    HELP! AVC Engaging While trying to Pull Start

    I had the same problem. I cleaned and lubricated the clutch properly, but it still engaged at idle. Then I found out that the engine I bought (Honda GC160) is set from the factory with a minimum idle of about 2000 rpm, and can not be lowered below this. In summary, I have to get a different...
  3. B

    honda gc160 / comet clutch help

    I have a new Honda GC160 with a comet 30 series clutch and torque converter mounted to it. The engine seems to idle high enough that it just engages the clutch. If I try to adjust the idle down further, the tall governor arm shuts off the engine. Can I remove the governor arm so I can adjust...
See more
Top