Recent content by Bmjo

So I have a yerf dog go kart with a 420cc and a torque converter it's fun and all in a straight line until about 40 where it tops out (was expecting more out of it) and it turns like **** due to the 100 pound motor in the back and I can't keep the front end on the ground. Should I sell the 420...

Nope I've replaced everything on this go kart brake drum,band,axle,all bearings,rims and tires,engine,torque converter, cables etc. I think it has to be something with the torque converter idk if I might put it on too tight because I really drilled it with the impact because I didn't want it...

30 series and the belt moves freely idk what's going. Everything I've gotten as far as parts is from gopowersports.

So the replacement parts came in today and I put it on looked good felt good no wobble at all. Then I took it out and was doing some donuts in the snow and then what I think is the torque converter locked up. The two back wheels will not roll they are locked up

I already ordered the replacement parts I'm not going to sweat it I heard kind of a scraping going on in there so I'm just gonna replace it

I guess it's out of alignment because it is very snug and doesn't even think about moving when I shake it with my hand. The other night the bolt came loose and the torque converter came apart but it didn't appear to be damaged so I put it back together

I finally got my go kart put together and I noticed thar my torque converter driver pulley seems to wobble a little bit is this normal? I used an impact to tighten the bolt on the shaft so I don't see how it could be loose

Went back and tried that today before heating it and it didn't work

Sprayed it with pb blaster everyday and today heated the hub and tried hitting it off. Still didn't work. Just ordered a new axle gonna cut the old one off tonight

That is the result I got using the puller

So I bought a yerf dog go kart last week and it was in desperate need of new tires so I ordered new tires and they came in today which became an all day deal. First tried hitting the backside of rim with a long piece of wood. Didn't work. Hub puller bent the rim. I tried everything even hooking...