Okay so I fixed the white smoke and oil problem. Now there is only a small problem left. The engine won't idle at all unless I hold the primer bulb in. I think my float is bad but I'm not sure. Thanks again everyone
I've run into a bigger problem I think. I was letting the engine idle and then I saw white smoke. At first it was a little but then it was more and more and now I can see oil near the spark plug.... I don't know what this means. But It worries me.
If its dented will it fall too low? I dunno how its dented but its not a flat loop anymore. Its indented on the bottom. I gotta burn the rest of the fuel off first...
OK thanks =) Well here's how today's gone so far.
New bowl nut =)
Fresh fuel. The other stuff was almost a year old. And now its ILDING!!!! Horray!!
BUT its dying out in the higher RPMs when it should start moving... I'm praying its not the carb but I have a feeling it is.
Sorry bout that. I realized I might be in the wrong part of the forum. I'm new to all this. And thanks for the advice tips and guidance in forum posting and repair. I took the carb apart and was cleaning it out. Then when I was putting it back together it just snapped and exploded on me. I also...
So if the fuel is old it'll cause it right? Gaskets are good. Compression is good. Spark is good. So the fuel itself might be bad? And should I use 91 or are lower grade fuels okay?
Tecumseh OHH60
We've owned a Manco Dingo SE6 with a Tecumseh OHH60 for about 10 years and its not been turned on or run in about 4 years. So I took it out and decided its time I try to drive it around.
Here's how that went...
First I couldn't get ti to idle. Got that fixed. The screw in the...
I guess the bigger problem is that I don't know much about engines haha. But I was able to drive it before I replaced the pipe and took the carb off. then it was taking in too much air because of the hole in the line from the carb to the engine. And now... Its dead.