Tecumseh OHH60 Help =(

Status
Not open for further replies.

bassestkkm

New member
Messages
16
Reaction score
0
Location
Riverside, California, USA
OK thanks =) Well here's how today's gone so far.
New bowl nut =)
Fresh fuel. The other stuff was almost a year old. And now its ILDING!!!! Horray!!

BUT its dying out in the higher RPMs when it should start moving... I'm praying its not the carb but I have a feeling it is.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
take the bottom bowl bolt off, and thats where the float is. The float may be damaged or filled with gas etc causing it to fall too low.
 

Attachments

  • O50-653.jpg
    O50-653.jpg
    10.5 KB · Views: 1

bassestkkm

New member
Messages
16
Reaction score
0
Location
Riverside, California, USA
If its dented will it fall too low? I dunno how its dented but its not a flat loop anymore. Its indented on the bottom. I gotta burn the rest of the fuel off first.
http://www.google.com/imgres?q=6400...&tbnw=119&start=0&ndsp=158&ved=1t:429,r:7,s:0

Should the bottom screw be coming out if its unscrewed all the way? As in should it be attached to anything. Also where should the top screw be? If I screw the top all the way in the throttle is activated and from there I can step on the gas freely. But its moving by then :arf:
 

bassestkkm

New member
Messages
16
Reaction score
0
Location
Riverside, California, USA
I've run into a bigger problem I think. I was letting the engine idle and then I saw white smoke. At first it was a little but then it was more and more and now I can see oil near the spark plug.... I don't know what this means. But It worries me.
 

the-cyborg

New member
Messages
476
Reaction score
6
Location
Spring, Texas
Make sure the crank case hasn't fill up with gas, sometimes if your float is stuck open it will flood the carb and migrate to the crankcase.
 

bassestkkm

New member
Messages
16
Reaction score
0
Location
Riverside, California, USA
Okay so I fixed the white smoke and oil problem. Now there is only a small problem left. The engine won't idle at all unless I hold the primer bulb in. I think my float is bad but I'm not sure. Thanks again everyone
 
Status
Not open for further replies.
Top