Tecumseh OHH60 Help =(

Status
Not open for further replies.

bassestkkm

New member
Messages
16
Reaction score
0
Location
Riverside, California, USA
We've owned a Manco Dingo SE6 with a Tecumseh OHH60 for about 10 years and its not been turned on or run in about 4 years. So I took it out and decided its time I try to drive it around.

Here's how that went...

First I couldn't get ti to idle. Got that fixed. The screw in the carb was shut...

Then The pipe from the carb to the top of the engine was cracked so I replaced that.

Now the darn thing refuses to turn on at all. I took the carb off and cleaned it but no luck.
I'm new to engine repairs and kinda need a walk through....

Thanks
Kish:confused:
 

B.M.800

TheBeal.
Messages
2,387
Reaction score
26
Location
Central PA
Spark?
Compression?
Fuel going to where its spose to?

Someone more knowledgeable than me will pop in soon enough...
 

bassestkkm

New member
Messages
16
Reaction score
0
Location
Riverside, California, USA
I guess the bigger problem is that I don't know much about engines haha. But I was able to drive it before I replaced the pipe and took the carb off. then it was taking in too much air because of the hole in the line from the carb to the engine. And now... Its dead.
 

bassestkkm

New member
Messages
16
Reaction score
0
Location
Riverside, California, USA
Tecumseh OHH60

We've owned a Manco Dingo SE6 with a Tecumseh OHH60 for about 10 years and its not been turned on or run in about 4 years. So I took it out and decided its time I try to drive it around.

Here's how that went...

First I couldn't get ti to idle. Got that fixed. The screw in the carb was shut...

Then The pipe from the carb to the top of the engine was cracked so I replaced that.

Now the darn thing refuses to turn on at all. I took the carb off and cleaned it but no luck.
I'm new to engine repairs and kinda need a walk through....

Thanks
Kish
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
1.pour a teaspoon of gas down the spark plug hole and see if the engine fires. if not try the below. If it does, you have a fuel issue or air leak. try choking the engine and try again.
you may still have dirt in the carb, something not back right, or damaged carb gaskets.
You also could have dirty fuel.
2. check compression (unlikely). put your finger over the spark plug hole. It should force it off. Bad compression is BAD! but unlikely to happen suddenly.
3. Check spark, by grounding the tip of the plug against the engine block and see if you get a spark. if this is bad, then it could be due to a faulty spark plug or ignition coil. Try a new plug first
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
1.pour a teaspoon of gas down the spark plug hole and see if the engine fires. if not try the below. If it does, you have a fuel issue or air leak. try choking the engine and try again.
you may still have dirt in the carb, something not back right, or damaged carb gaskets.
You also could have dirty fuel.
2. check compression (unlikely). put your finger over the spark plug hole. It should force it off. Bad compression is BAD! but unlikely to happen suddenly.
3. Check spark, by grounding the tip of the plug against the engine block and see if you get a spark. if this is bad, then it could be due to a faulty spark plug or ignition coil. Try a new plug first
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
Old fuel may cause a problem, however in this case I would have thiught it was the carb. Try boiling it in lemon juice.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
A major problem- as in, ain't gonna run. Fix that problem first. And- how on earth did that happen?

Also- please avoid starting more than one thread on the same topic or question. I have merged your two threads. And welcome to the forum!
 

bassestkkm

New member
Messages
16
Reaction score
0
Location
Riverside, California, USA
Sorry bout that. I realized I might be in the wrong part of the forum. I'm new to all this. And thanks for the advice tips and guidance in forum posting and repair. I took the carb apart and was cleaning it out. Then when I was putting it back together it just snapped and exploded on me. I also got a new can of gas so after getting the nut tomorrow I'll post depending on what happens. Thanks Again. And Sorry
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Nice! Regarding your octane question- there is no benefit to higher octane fuel in a stock industrial engine. It only becomes beneficial when the engine is modified for higher compression ratios.
 
Status
Not open for further replies.
Top