Recent content by aj992

No need to clean carb, maybe if it were a 4 stroke but you're able to adjust the jets from the outside on these. There should be 2 little screws on the side of the carb (like the red and black one in the photo I attached), turning these effect the amount of fuel going into the carb, you're...

Thanks for all the help guys. I ended up ordering some Yamalube 2R and am gonna give that a try... And just for the record, no, I did not put oil in my crankcase but I can't blame you for asking, sid:lolgoku:

Thanks for the reply Sid I am currently using what the previous owner also instructed me to use - https://www.amsoil.com/shop/by-product/motor-oil/2-stroke/dominator-synthetic-2-stroke-racing-oil/?code=TDRQT-EA with 91 octane non-oxy gas.

Before you all crucify me for creating a thread of a already greatly talked about subject please understand that I have read through boatloads of strings about this but cannot find any that pertain to my exact problem. I have a KT100 with a two hole intake on a Walbro WB3A carb with a four hole...

I just bought a kart with a KT100 with a 2 hole air box and 4 hole can. I am wondering what the differences are between air boxes and air filters on these two stroke engines. And the difference between cans and pipes. Pros and cons? Which offers more performance? Realibility? Thanks!

I am wondering what the high and low settings on the KT100 actually do. I'm not wondering what to set them at, I've found plenty of threads on that but I am curious as to what you're actually changing when you screw those in or out? Thanks.

Came filled. Don't know about bled ---------- Post added at 06:36 PM ---------- Previous post was at 06:32 PM ---------- Yeah I'll attach some in a bit

Your axle size depends on bearing size which depends on the flange size.

I'm going to start by saying I know absolutely zero about brakes and today I got the hydraulic brakes for my go kart. Now me being me I had to test them out and first thing I did was push in on the master cylinder and close the brake. After doing that a couple times it doesn't open back up...

All I was looking for - thanks

I picked up some tires the other day 10.5x4.5-6 for the front and 11.5x6.5-6 in the back. Now my question is can I run a 5 inch wide rim in the front and a 7 inch wide rim in the back? Will the tires still mount? Thanks

Help with wheels I picked up some cheap, used racing slick today to get me started off. Now I need to buy rims. I'm struggling with the width I need. This is because the width stated on the front tires say 4.5 inch but if you measure bead to bead it looks like 5.5 or 6 inch (see pictures). Same...

How can I increase the oversteer on my kart? Also how can I achieve an increased steering angle?

I don't believe that speed calculator. It told me I would only be able to do 26mph. Well, I finished my kart and clocked it and I was able to get to 37mph.

Need some rims that are 6in high & 6in wide. LMK if you have some.