Recent content by Agent_Orange

Head lamp mounted to fork axle on a fanned up tab. 16 gauge sheet metal twisted and welded for custom throttle linkage. Rear light mounted to welded side tab. Chain guard is an old recoil cover opened up, short pieces of coat hanger stiffen the tail of the guard. And lights are set on a toggle...

More pics

Swapped out the 97CC for a 331cc tecumseh.Fabbed up throttle linkage, chain pensioner. Extended the bike frame 10" longer and foot pegs out 4" additional. Custom chain guard. And working on wiring up lights front and rear

A shot before all the glitz and glam of the paint. plus it shows the drive line set up. that was covered by the guarding i put in place. it looked like quite the meat grinder.

As she sits now, I had some scrap steel that i utilized to cover all the drive line chains, jack shaft and track for safety purposes. I first hand how quickly a chain and sprocket can take of 1.5 fingers and my little girl doesn't need that to happen. So i my have to re design the seat and move...

EPIC ENGINEERING FAILURE!!!! she sled runs great. turns a good tight radius, track has plenty of torque and she takes off like a raped ape... but... my design has the center of gravity too forward w/ the rider... the instant I throttle up the sled nose dives and no traction to the tracks...

Parts came in the mail and the first thing I want to do is apologize to everyone... I didn't take pics as I was installing and fabricating, as I was toooo excited. got the drive line situmagated and fired up the motor. everything worked so far as it should. after a few minutes of warm up I...

still waiting on parts for the drive line, so.... I grinded down the welds on the front cowl and gave it a thin coat of body filler to make the edges and corners look nice. should clean up real nice with a bit of sanding.

couple coats of primer on the front after she's all skinned over

silly question but if there are set screws on the clutch did you back them out?

Clutch and Jack Shaft ordered :wai:

any reason i shouldn't put the clutch in the JS? other than the JS spinning at the same RPM as the crank at idle.

I'll keep it PG for eveyone (plus i don't want to get banned) up date. McMaster-Car drive sprocket, axle sprocket and JS sprocket. need to order the JS and the clutch now. in the time being i am covering the front of the sled in sheet metal to give it more of a sled shape. pics up soon.

McMaster-Carr parts ordered :)

it should work fine just changing out the sliis for wheels. much like a Can Am Spyder...