bob58o
SuckSqueezeBangBlow
So if trying to remove a live axle and it doesn't want to slide through the bearings because there are burrs on the axle from the set screws of the bearings, how does one remove the burrs on the axle from the bearing set screws since the burrs are down inside the set screw holes?
Maybe the 4lb dead blow hammer isn't big enough?
I guess a rotary tool with small attachment to clean it up?
Also does anybody know how much wood a woodchuck chucks?
Maybe the 4lb dead blow hammer isn't big enough?
I guess a rotary tool with small attachment to clean it up?
Also does anybody know how much wood a woodchuck chucks?