Yamakoyo (GX200) clone

Status
Not open for further replies.

Wim

Jazz Maverick
Messages
87
Reaction score
0
Location
Oz
I have one of those Chinese Drift2 karts with a 6.5hp clone engine, which Ive run hard offroad for about 40 hours. Last week I my karting came to an abrupt halt when I noticed a large amount of oil leaking out of clutch-side of the crankcase.

When I got it home and had a look it turns out one of the bolts had snapped off and the remaining bolts were variously loose. I know Chinese "high tensile" bolts are more like mild steel so this wasnt totally unexpected. One good thing is the softness of the bolt made it easier to drill out.

I replaced all the bolts with -real- high tensile bolts and reassembled but then noticed the engine was quite a bit harder to pullstart, (as if the compression was greater than before). I hadnt pulled one of these engines apart before but I was aware of two possibilities;

1. the easy start was jammed off.

2. the timing gears have slipped with the case being loose and changed the valve timing.

After opening it up again I pulled the camshaft out to get a look at the easy start, it was worn but moves freely.

Next I replaced (put back) the camshaft making sure both gear marks were at top-dead-centre and reassembled.

Gave it a pull and all is new, started first time.

So, things I learnt that might help others:

-Replace crucial bolts, or check regularly.

-How the easy start works and how it wears.

-How the timing gears align.

-the valve system design in one of these engines (cheap and cheerful). :thumbsup:
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
by replacing the camshaft you meant put it back, not get a new one right?

well, good advice there.!
 

Wim

Jazz Maverick
Messages
87
Reaction score
0
Location
Oz
Yeh, just put it back. It didnt have any visible damage or wear.
I thought I mightve bent a pushrod but they're ok too.
 

Wim

Jazz Maverick
Messages
87
Reaction score
0
Location
Oz
I dont know. Would this happen if the cam shaft slipped a tooth and advanced/retarded timing?

I'm guessing the easy start might have been jammed but came loose when I removed the cam shaft?
 
Status
Not open for further replies.
Top