Worn weight assembly?

Status
Not open for further replies.

8t6bronco

New member
Messages
53
Reaction score
1
Location
Owensboro, Ky
Cleaning and servicing a knockoff tav2 that came on a Baja Blaster 65. The weight assembly in the driver looks worn to me, I don't care to spend the money to replace it if need be. This is the first time I've been in one of these so I wanted to get some opinions from the forum, preferably from those who have successfully cleaned and repaired these before.

Edit: it looks like the holes the pins go through are worn to me
 

Attachments

  • image.jpg
    image.jpg
    166.1 KB · Views: 11

KartFab

Active member
Messages
3,381
Reaction score
60
Location
Dallas, TX
If the springs are curved when disconnected, you should just get a new shoe assembly. If the springs are shot, you get poor early engagement.

The holes, when wallowed out, can cause the weights to come apart unevenly and stick engaged and bend the posts that they ride on.

If it works fine then why 'fix it?'
 

8t6bronco

New member
Messages
53
Reaction score
1
Location
Owensboro, Ky
If the springs are curved when disconnected, you should just get a new shoe assembly. If the springs are shot, you get poor early engagement.

The holes, when wallowed out, can cause the weights to come apart unevenly and stick engaged and bend the posts that they ride on.

If it works fine then why 'fix it?'

The springs where curved after disassembly, so I ordered new springs.

The main reason I took this apart was because it would stick engaged and kill the engine when you slowed down. So I will order a new weight assembly too. Thanks for your help.
 

KartFab

Active member
Messages
3,381
Reaction score
60
Location
Dallas, TX
You also need to thoroughly clean the hubs (the one that goes on shaft and the one that is attached to the moveable sheave. Just wire brush them out. That is another common source of problems. Also, it doesn't hurt to spray a quick squirt of dry graphite or dry molybdenum on the hub.
 

8t6bronco

New member
Messages
53
Reaction score
1
Location
Owensboro, Ky
You also need to thoroughly clean the hubs (the one that goes on shaft and the one that is attached to the moveable sheave. Just wire brush them out. That is another common source of problems. Also, it doesn't hurt to spray a quick squirt of dry graphite or dry molybdenum on the hub.

I've watched your YouTube videos on cleaning torque converters, thank you by the way, I plan to do all this before re-assembly.
 
Status
Not open for further replies.
Top