Working on a kart...

[Mkyxd]

Dismantled to take to work tomorrow. Will find a bolt to work. 1-1/8 nut had to borrow a socket. Manual said it was a 3/4. Lies lol.

 

[Mkyxd]

......

 

[mckutzy]

So if you are missing the adjusting bolt and jamb nut, do you have the caliper piston(a small bullet shaped piece of steel, has a flat end and hemispherical head)?
If this is missing, the adjusting bolt is the least of your worries.... As this holds the piston captive, and is critical to the whole caliper functioning...

 

[Mkyxd]

Yes had the caliper piston. 7/16-20 a little work with my grinder and shes running and stopping. May go with a karger engine next year. As this one barely hauls my 250lb butt up the hill outback. But the kids are enjoying it so far.

 

[Whitetrashrocker]

Good to hear your up and running.