WHOA! Engine stopped running with a bang!

Status
Not open for further replies.

dictionary6767

New member
Messages
249
Reaction score
0
Location
Nj
I have a Yerfdog that I was driving today and heard some kind of grinding noise and a pop then the engine stopped abruptly. First thing I thought was the timing chain, but checked that out and it's still there! If I turn the flywheel it sounds like a grinding noise in the crankase and I can't turn the flywheel a full rotation either way -- it stops just before the T mark in both directions. Before this it started and ran perfectly, I had no indication anything was going wrong. Any ideas where to look next? Oh, if I try to start it, it turns but doesn't sound at all like it's going to start and sounds like a knock in it. Thanks in advance. :mad2:
 

SmallEngineDave

New member
Messages
28
Reaction score
0
Sounds like a shattered connecting rod
I took in an outboard for repairs and the exact same symptoms of your engine. I found the connecting rod in the reeds, other cylinder, bottom of the crankase...
To this day I havent found every peice of the rod

Split the cases, see whats up.
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
did you have good/ any oil in it at all?

usually the connecting rods punch a hole right through the side of the engine.. especially a tecumseh... but sometimes you get lucky and it just hits the side of the cylinder without damaging it.
 

dictionary6767

New member
Messages
249
Reaction score
0
Location
Nj
I'm going to take it apart, assuming it's the connecting rod. Where can I find a new connecting rod? BMIKarts doesn't have them, and I don't know where else to look.
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
what motor? 5.5 powersport?

take it apart first, sometimes when a rod goes, the camshaft breaks as well. who knows, the connecting rod may be fine and there may be a hole in your piston from a valve head breaking off.

check ebay but see what broke before you buy.
 

dictionary6767

New member
Messages
249
Reaction score
0
Location
Nj
what motor? 5.5 powersport?

take it apart first, sometimes when a rod goes, the camshaft breaks as well. who knows, the connecting rod may be fine and there may be a hole in your piston from a valve head breaking off.

check ebay but see what broke before you buy.

No it's a 7.8 hp. eBay doesn't have it either
 

DirtTrackRacer_07

DeeR SlayeR
Messages
222
Reaction score
1
Location
tennessee
Pull your spark plug out and put your finger over it. See if it will push air out any at all on your finger when you turn the flywheel back and forth.

If it does your connecting rod is still good and you probably dropped a valve.

If it doesn't and the flywheel spins freely back and forth like there is no restainst on it, more than likely broke connection rod.

You can diagnose it easy by pulling the head off.

But if you can spin the flywheel and don't see no hole in the side of the block, you have already had good luck to start with.
 

dictionary6767

New member
Messages
249
Reaction score
0
Location
Nj
well, I took the cylinder head off and take a look at what I found:



I guess that valve came out and got rammed up into the cylinder head by the piston. Where's the best place to get a new head?
 
Status
Not open for further replies.
Top