Which Sprocket/Gear Ratio?

Status
Not open for further replies.

Kenpilot

New member
Messages
19
Reaction score
0
Hey guys, new to the forum and new to Go Kart Building. I'm trying to decide on a Sprocket size for my live rear axle. I have an 8HP Briggs engine, plan on using 15inch tires, and will be putting a Torque Converter on it.
http://www.bmikarts.com/item/Comet-TAV2-Torque-Converter-218352-218353-218354-or-218355-646

1 inch bore, #41 sprocket (10T sprocket on the converter to the axle sprocket).

I plan on using the Kart mostly off road/dirt roads and some hilly/rough terrain. So I guess I need something with more low end torque rather then higher top speed. Thanks in advance!!
 

klicky96

New member
Messages
558
Reaction score
1
Location
Sandusky, Ohio
You should probably get the torque converter first. Then put maybe a 60 or 72 tooth sprocket on the rear. The torque will give you enough torque, but don't go too small on the rear axle.
 

Kenpilot

New member
Messages
19
Reaction score
0
I was thinking about putting a 72T sprocket on the rear axle but I haven't been able to find a 72T #40/41 Sprocket. I have been able to find a 60T 40/41 sprocket so I'll probably just go ahead and get that but I'll wait and see if anybody else chimes in with some more info. Thanks for the response!
 

B.M.800

TheBeal.
Messages
2,387
Reaction score
26
Location
Central PA
I cant say for sure, but a 60t sprocket may be fine for what you want to do...
There is a way to figure it all out, but its over my head...
 

klicky96

New member
Messages
558
Reaction score
1
Location
Sandusky, Ohio
Your running 15inch tires. So a sprocket approximately 10-12 inches in diameter would work good and give you a lot of torque without the torque converter. But with the torque converter, the 60 tooth sprocket should be alright.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
60 will be fine.
If you find any larger #40 sprockets, could you please share the link? I wouldn't mind one :)
 

Kenpilot

New member
Messages
19
Reaction score
0
I went ahead and ordered a 60T sprocket for the axle. I couldn't find anything bigger for a #40 unfortunately. Thanks for the replies and suggestions!!
 
Status
Not open for further replies.
Top