Whats better? Rod or Cable for brakes and Gas

Status
Not open for further replies.

mbennett66

New member
Messages
21
Reaction score
0
Hello all I just wanted to get some opinions and maybe see some of your setups.

The kart I got had rod linkage for the band brake and a rod/cable combo for the fuel. The fuel rod went about 3/4 back where it connected to a cable that worked the fuel lever on the motor.

I would like to go with full cable on both if it will work.

Thanks in advance.
 

jarcynvicnchris93

New member
Messages
180
Reaction score
1
I agree

I like a rod for brakes, don't have to worry about stretch, but a cable for gas, because you can easily manipulate where it goes and how it behaves.

:iagree: :iagree: unless of course you put your brake handle on the steering wheel like the Honda Odyssey
 

mbennett66

New member
Messages
21
Reaction score
0
Thanks everyone. The current setup on the kart I am rebuilding was rod for the brakes. I was a little concerned with the rod because I am planning on moving the pedals inboard from the front corner of the kart for my 5yr old son.

When I move it in, it will not be a straight shot back to the band brake down the side of the kart like it is now. If I keep the brake rod going down the side of the kart, it will have long (4 or 5 inches) "L" bend at the pedal end to reach the pedal. If I do that I may have to brace the "L" to minimize the flex in that bend when force is applied to the pedal. I may try to figure out something else to do with the pedal as well.

Any recommendations are appreciated.
 

dpaxson

New member
Messages
346
Reaction score
0
Location
parma heights, oh
cable would work fine just make sure you use something pretty thick. like a front brake cable from a moped or an older drum brake dirt bike. a bike cable will probably just stretch.
 

Ibnzmonkey

Keep Austin Weird
Messages
207
Reaction score
1
Location
Austin Tx
I use a cable for my rear brake. Its actually 3 pieces of Aircraft safety wire braided together. works amazingly well, no stretching and great tensile strength.
 
Status
Not open for further replies.
Top