Just picked up a Coleman ct 200 u . Did the stage 1 upgrade ( header , intake , rejet carb , and the governor zip tie trick temporarily. Going to upgrade my valve springs to 18lbs noticed engine has a little sputter at higher rpms . Just need to know the correct number that my Valve lashes should be set to . Thanks
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
What should valve lashes be set to ct200 u
- Thread starter Noel85
- Start date
mckutzy
Well-known member
Hello and welcome...
Remove the zip asap.. unless you want a con-rod to the jewels.....
And also ditch the valve springs and keep the stock, as you have a stock con-rod, that would be a weakest link for a rapid disaster dissection recipe...
So stock rod, stock springs. New springs, new rod.... And this is with the gov removed completely inside and out.
Remove the zip asap.. unless you want a con-rod to the jewels.....
And also ditch the valve springs and keep the stock, as you have a stock con-rod, that would be a weakest link for a rapid disaster dissection recipe...
So stock rod, stock springs. New springs, new rod.... And this is with the gov removed completely inside and out.
mckutzy
Well-known member
Yes they would.. but to the benefit of allowing to act as a governor, short of the threshold of the con-rod letting go...