What should i do?

Status
Not open for further replies.

Thedude

New member
Messages
102
Reaction score
0
Location
Washington State
I got an 8hp briggs and stratton engine with a 1 inch crankshaft. I need a cent. clutch but 1 inch cent. clutches are $120! Im only 13 I don't have enof money to spend $120 on just the clutch. Should I get a new engine? Use a different type of clutch? What do you think?
 

solomon

Active member
Messages
1,648
Reaction score
8
Location
ca
You can have a few options. You could run direct drive,Run a pulley setup instead of chain.
You could also have the crankshaft turned down to 3/4" at a machine shop. If you are real cheap it is not recommended but you can grab some files and start up the engine, and carefully file the crankshaft down until your clutch fits. Then make a key way or drill 2 smaller holes about the same size as the set screws that come with your clutch and then torque them down with the clutch so it doesn't slip under load..
 

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
try setting up somthing like this. put a 1" bore sprocket on your engine then a 3/4" bore sprocket with the same number of teeth as the 1" bore sprocket on a 3/4 in jack shaft. finnaly put a 3/4 in bore clutch on the jack shaft, run chain from that clutch to the sprocket on your axle. make shure the direct drive sprockets have a 1 to 1 rateo so that the clutch will engage at its factory set rpm engagement. good luck :thumbsup:
 

redsox985

Active member
Messages
4,092
Reaction score
12
Location
PA
Check Ebay for clutches. You should be able to find one cheaper.

Well this one isn't $90

Or just shell out the $$$ for a 1" torque converter. You won't be disappointed with it. If 1" clutches are almost $80, BMI Karts has 1" TAV2 torque converters for like 3 clutches value. You'd have to buy the components separately because they do not have a complete assembly package. If you do any offroading you'll eat up $80 clutches but the TAV2 will handle it easily
 
Status
Not open for further replies.
Top