What exactly is a "back fire"?

Status
Not open for further replies.

outdooz

New member
Messages
99
Reaction score
0
My engine used to back fire from the muffleler. What is it? and is it bad or how to stop it?
 

redsox985

Active member
Messages
4,092
Reaction score
12
Location
PA
I thought it had to do with the valves not seating entirely at combustion allowing some gases to escape out the carb? I could very likely be wrong but I have see it happen out the carb.
 

fowler

New member
Messages
5,463
Reaction score
18
Location
Bullsbrook West Aus
back fire as in firing back up the system

iv seemn it in cars when the spark timing isnt right
hence the spark is firing while the fuel is being injected

there are many things to cause it
 

The Mechtician

Gargamel Jr.
Messages
183
Reaction score
1
Location
Surrey, BC, Canada
There are two kinds of backfires; intake backfires and exhaust backfires.

Intake backfires happen when the timing mechanism fails and cam timing becomes retarded (eg; timing belt or chain skips a tooth, dowel/key on cam sprocket breaks and sprocket moves relative to cam, etc). This causes the intake valve to close late enough that combustion starts before it's fully seated. It can also be caused by a cracked or bent intake valve, or ignition timing that has been advanced too far. On DOHC engines, sometimes the timing belt can skip a tooth on only one cam, which can lead to all kinds of weird behavior.

Exhaust backfires are typically caused by an overly rich air-fuel mix and/or ignition timing that's been retarded too far. Also, in multi-cylinder engines, if one cylinder is misfiring badly it can cause backfires (since that cylinder is basically pumping unburned fuel into the exhaust).
 

sideways

Unfinished projects king.
Messages
1,501
Reaction score
2
Location
Perth, Western Australia
A back fire originally meant when the engine's spark was advanced too much at low revs and the engine would spin over backwards. It has grown to mean a loud bang or pop that comes from anywhere in the engine. It can be caused by old fuel, both running to lean or too rich (usually lean), timing being out, valves not seating ect ect.
 
Status
Not open for further replies.
Top