what carb

Status
Not open for further replies.

woodt8369

New member
Messages
16
Reaction score
0
I heve 6.5 clone with gov removed and 18lbs springs stock head with .065 milled off cold air intake #78 main jet and drilled my idle jet to .020 and valve filter and gx 140 emulsion tube is it nessecary to upgrade my carb or leave it and if i should upgrade what is better th gx 390 bored or the mikuni
 

Jdominique

New member
Messages
74
Reaction score
0
Hey bro, I think your main jet size is too small. With a filter and header, most builders use a #90 or #92 main jet.
 

1992suburban

I wanna go FAST!!
Messages
1,061
Reaction score
1
Location
Sanford, NC
with a 140 etube it will have higher "fuel pressure" so it uses a smaller jet then "most" run with the stock etube

depending on the hole count in the e-tube less holes gives more fuel pressure/signal..
 

dmaznic

dmaznic
Messages
46
Reaction score
0
Location
Toronto
for the same fuel mass let's say, is it better to adjust the main jet or the etube/nozzle? From what I can deduce, the nozzle adjusts the air/fuel pre-mixture before it enters the carb tunnel. So if you have a smaller nozzle you just get a purge of unmixed fuel (maybe better for curved manifolds). With a bigger main jet, there may be a little less fuel but it will be mixed better.
Thoughts?
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
Old thread...
But to answer your question, I would get a 140 e tube and go from there. The 140 tube is meant to provide more even fuel flow throughout the rpm range.
 
Status
Not open for further replies.
Top