Weed whacker idle

Status
Not open for further replies.

CaptCanadia

New member
Messages
792
Reaction score
1
Location
Acton, CA USA
Okay so I posted this in an earlier thread but it wasn't resolved. The problem is when I idle it for about 5-10 seconds it will die out. Can I do anything to fix this?
 

CaptCanadia

New member
Messages
792
Reaction score
1
Location
Acton, CA USA
It has like 3 stages. First to prime 2nd to warm up and 3 to operate. It has a primer bulb like a 2 stroke carb (which it is) and a pull start. It has one screw, but i donno if it's the idle screw?
 

ipwnr

Member
Messages
86
Reaction score
0
Location
toronto ontario
next time when you turn it on just play with that screw if its the idle screw turn it clockwise to bring the idle higher and counter clockwise to bring the idle lower. and you won't know till you try:)
 

redsox985

Active member
Messages
4,092
Reaction score
12
Location
PA
It has like 3 stages. First to prime 2nd to warm up and 3 to operate. It has a primer bulb like a 2 stroke carb (which it is) and a pull start.

The 3 stages are choke, half choke, and run. That's what prime, warm up, and operate are.

It has one screw, but i donno if it's the idle screw?

That's most likely the idle screw. If you pull the trigger, does the little plate pulled by the trigger cable disengage from this screw?
 

sexyvicta

New member
Messages
806
Reaction score
2
then idle speed(throttle position) is probably not your problem. I would say low speed is too lean...for whatever reason. Does this have high and low speed screws? or is it a new emmisions spec carb?
 

CaptCanadia

New member
Messages
792
Reaction score
1
Location
Acton, CA USA
Well I'm not really sure. It doesn't struggle to rev, but it's delayed. If I have the throttle off and I pull it all the way, it will take like 2-3 seconds to actually rev up to that.
 

ipwnr

Member
Messages
86
Reaction score
0
Location
toronto ontario
o ok now i get it i have the exact same symptoms on my pocket bike and the problem on that is that there is a air leak between the manifold and carb/engine i still can't find of fix the leak so yeah you are running lean so try to tighten every bolt and check gaskets
 

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
why kind of weed whacker? my old home lite, had a peice of steel meshing as like an air filter, it got so clogged up it let no air in, therefore making it run way to rich,
 

95badbird

New member
Messages
80
Reaction score
0
Location
Srping TX
my brother had a Bolen's weed eater......hate to sat it, but that thing was pure JUNK!
best thing we ever did was wrap it around a tree.

I recently bought a Stihl....best purchase I've ever made when it comes to lawn equipment.
 
Status
Not open for further replies.
Top