wavy washer

Status
Not open for further replies.

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
ok, so i was diagnosing the engine today with the neighbor, and we realized, gas was leaking from the on off valve of the carb, down and acting like it was coming from the sediment bowl, so i tore it apart, and found the wavy washer that was on top of the valve was missing, when i buy a new washer, does it have to be bent up like the old one?
 

anderkart

Moderator
Messages
6,432
Reaction score
392
Location
Surprise Arizona USA
You'd probably find a good hardware store would stock a selection of wavy spring washers. Or If they had any thin thrust washers, you could do a series of bends to it... Or Maybe installing an O-ring sandwiched between 2 thin thrust washers instead might work.

You just need some means to apply the proper tension to hold the petcock up against its seal, while still allowing the petcock to turn, but not turn so easily it turns by itself from the engines vibrations.
 

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
ive been through 3 stores, 2 small engine stores, one hardware store, and none whatsoever carry the spring washer in the size needed
 

kendelrk

redneck engineer
Messages
2,425
Reaction score
9
Location
westland michigan
what i ended up doing was, i was at the neighbors and we were working on his, ( changing clutches/moving the motor mount washers out,) and he had a bunch of left over O-rings from his master cylinder rebuild kit, so we took one close the size and made a cut since it was a thicker washer, pulled it out the back of the cover and it hasent leaked at all
 
Status
Not open for further replies.
Top