Thanks for the quick reply.
I'm hoping there will be enough vacumn seal from the new carb ive got to shut the valve, thats the idea for the spacer piece with the pipe fitting.
I plan on getting rid of the g4 asap haha. I had a choice between a g3 and a g4 but the mower that the g3 was on was in really poor condition and the starter seemed stuffed. So i went with the other cause ive got a briggs carb to replace it, just like brendonv's if you have seen his one. Its on here somewhere.
I think i got lucky with my engine. The compression is quite good and it had a good spark. Although i may give it a rebuild and port the inlet one day. I got degreaser and water under the flywheel when i was cleaning the gunk off it though and it fried the condensor. $15 later and it was working fine.
It's smokey but im hoping its cause my fuel is pretty old. Weird thing is it only started smoking once i put the new condenser in. Could be a better spark is burning the oil more and creating smoke.
I think when the starter is grabbing on the cup a bit of oil or something is making it slip. Hopefully easy to fix. New starter cups are pretty cheap anyway if it does wear out.
Ill get some good pictures up tomorrow when theres some light haha. And your right about the model. Its a MK 4. I know because it still had the original metal film sticker attached to the cowling. I think whoever owned it took real good care of it.
My plan is to get the original blade boss off the shaft and machine it down to 3/4" on my schools metal lathe. Havent worked out the other half of the adaptor yet.
Does anyone make them other than gaspares? Cause they seem to charge a fair bit for two little pieces of steel. I guess they probably only make small numbers of them cause not many people need them.
I've actually been a member since late 2009. Only remembered i had an account the other day when i really got back into my victa kart. Haha that pretty much means im still a new guy.
Thanks
The vacuum from the new carb should be fine, the decomp valves usually just close by them selves anyway.
If you can, I'd grab that other mower, it's good to have spares, then you can experiment with porting and shaved heads ect too.

Briggs carb should be fine, it's a fair bit of work to fit them though, I imagine the jetting would be way out for a Victa too.
IMO all Victas seem to have really good compression, even the really worn out ones. Points Victas usually have dead condenser, yours was on the probably on the way out anyway. You can use the electronic ignition from a Power Torque or later full crank, if you want to do that then I can show you how to wire it?
As for the smoke, see my comment in the other thread, you could of accidentally changed then timing too.
Starters are usually very easy to fix, as I said, normally just a bit of dirt gets in there and jams it.
Cool, mark 4 and mark 3 are basically the same, just minor differences in the carb.
Good luck with machining the boss down, I've always wanted to try it but either didn't have access to a lathe or found better ways of doing it. The easiest way to get it off is to hit each side of it with a ball pein hammer. I have gotten them off with just a normal hammer and a lot of swearing though. The thread is 1/2" BSF and the taper is 15 degrees if that helps at all. What I do is get 1/2" pulleys and cut my own key way in the shaft. I don't really like centrifugal clutches to yeah. If you could find a 1/2" cent clutch you could just cut a key way in the shaft but one of those would be near impossible to find.
None that I know of, you can get the pulley off the bottom of a 24" cut Victa but other than those there are no off the shelf adapters/pulleys that I know of.
Thanks
Hayden