very loud 5.5 brigs intec

Status
Not open for further replies.

WHOTEN

New member
Messages
2
Reaction score
0
Hello...

The fox 2x5 lxt i just bought has a briggs 5.5hp intec 206 and is extremely loud compared to a larger but similar briggs on my snow thrower.

The muffler starts as a flange on the top of the engine then is a 1" diameter pipe that goes up a couple of inches then 90 degrees to about 2" then a can at the end of the pipe. The briggs parts lists shows two other variants for the same engine.
(see attached pdf )

Does anyone know which is the most quiet version?

Does anyone know of ways to make this more quiet even at the expense of performance?

Has anyone had any luck with the supertrapp 5s or other silencer variations?

Thanks for any help!

Whoten
 

Attachments

  • muffler.pdf
    136 KB · Views: 18
Last edited:

exenos

Project Nut
Messages
1,217
Reaction score
0
Location
Ontario, Canada
I used a Large diameter (2") open pipe with a few bends it it on my clone and it was a bit quieter than it was with the stock muffler. If i placed a sealed off coffee can with another exit tube over the exhaust then it became even more quiet. I would just play around with diferent length of pipe and diferent "Mufflers" placed at the end or somewhere along it.
 

exenos

Project Nut
Messages
1,217
Reaction score
0
Location
Ontario, Canada
Nope, didn't even show any signed of distortion or warping. It was separated from the engine by a long piece of tubing though.
 
Status
Not open for further replies.
Top