Vector Go Kart pulley question, I'm clueless

Status
Not open for further replies.

gofortheheart

New member
Messages
6
Reaction score
0
Location
South Carolina
I just bought my boys a Vector 4170 with a 6 hp Subaru engine. I had to put a new belt on it, but after a little while the belt started making a little bit of noise and the kart wanted to move forward even when the throttle wasn't being pushed. I took the belt cover back off and it appeared the rear pulley (I have no idea what it's called) was kinda jammed shut on the belt. I could not turn the spring loaded area at all to free up tension on it. Well, I took the belt off and as soon as I did, the thing freed up. Does the spring loaded part need to be lubricated or something? It doesn't look like a normal "clutch" to me. The manual for this thing is absolutely no help at all. Thanks!
 

Kaptain Krunch

Pro Junk Collector
Messages
4,636
Reaction score
6
Location
vermont
The pulley your speaking of must be the one on the jack shaft? (not on the engine). If so, that is called the secondary, or driven pulley. it does not release the belt, that is the primarys job (pulley that is on the engine). At idle, the belt should not move, did your belt get stuck "down" in the secondary?

By the way, this section is fine, no need to worry.
 

gofortheheart

New member
Messages
6
Reaction score
0
Location
South Carolina
it appears that the driven pulley is closing up to the point that it forces the belt way out near the outer edge which is pulling the belt tight against the engine shaft where the clutch is
 

Kaptain Krunch

Pro Junk Collector
Messages
4,636
Reaction score
6
Location
vermont
It is supposed to close that much at idle, top of the belt should be flush, or a little above, the pulley sheave. Sounds like you may have too short of a belt.
 

dfarrell8

New member
Messages
1
Reaction score
0
Hi all, new to this forum and have a question on this Vector clutch also. Having the same problem as gofortheheart. I have a golf cart and have replaced my driven clutch a few times so are these similar? Not sure what is causing the clutch to stay engaged? Maybe dirty? Any ideas?

Thanks.

Don
 

fowler

New member
Messages
5,463
Reaction score
18
Location
Bullsbrook West Aus
start your own thread if u cant find the relivant info in this one.
u should also try and search for other threads first.
 
Status
Not open for further replies.
Top