V6 4x4 truck engine in a yerf dog 3203?

[JacobDickson]

I have a old truck in my drive way it's a ram it's from 1975 it runs well just the whole body and undercarriage is rusted and the frame is bent. I don't want to completely scrap it so I was wondering if it was possible to throw the engine on my go kart.

 

[Poboy kartman]

Yeah....you can throw it on there...it'll keep it off the ground while you look for a vehicle to put it in and shop for a new gokart frame!

 

[Kahrese lee]

To heavy for little cheap yerf dog frames probably crush it

 

[Zombient]

No.

 

[ezcome-ezgo]

75 Dodge trucks didn't have V-6 engines. Therefore, your argument is invalid.

 

[J_Walker]

75 Dodge trucks didn't have V-6 engines. Therefore, your argument is invalid.

maybe its been replaced since then..?

 

[mckutzy]

With a v6???? Really..

 

[chancer]

I say go for it!

 

[Denny]

It should be a bolt in, according to the internet anyways. You will just have to make brackets for the radiator.

Denny

 

[rushking19]

Yeah it will work your go Kart frame and axle may bend but you will be fine, am you have to do is bolt a centrifugal clutch to Iran's your fine

 

[rocketkart]

Yeah it will work your go Kart frame and axle may bend but you will be fine, am you have to do is bolt a centrifugal clutch to Iran's your fine

WTF all you need to do is it get a flux capacitor and plug it in the the 90000cc trex engine powerd with a super toilet turbo. than you need the adapter plate for the ls4g11 bracket plate thats for the super duper dilithium crystals pawerd trans. with all that you should be good to go !!!!

 

[ML-TOYS]

If you turn the motor sideways you can mount a wheel to the torque converter if its automatic, or to the clutch.

 

[mckutzy]

IBTL....


Nuff said.

 

[Zombient]

Is this the same kid who wanted to use a parachute as a brake?

 

[mckutzy]

Hahaha.. No. I did however look that up though, just to check.

 

[OzFab]

Ok, enough of the sarcasm & bad advice; again, this is NOT how we treat noobs...

Jacob, no, you cannot mount a car/small truck engine to a go kart frame; the very least that type of engine can be mounted to is a purpose built chassis made from much stronger material than any go kart frame...