Upgrade valve springs?

Status
Not open for further replies.

CaptCanadia

New member
Messages
792
Reaction score
1
Location
Acton, CA USA
Well I have these new valve springs but I'm feeling lazy. Do these things help the engine at all? Is it worth changing the springs on a near stock engine or no?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
No point with other stock internals. You really only need to consider stiffer valvesprings if you pan on tunrning higher RPM. Now, bear in mind the following. If you remove your governor and the reciprocating assemblies are still stock, it is considered a good idea to leave the stock springs as they will have a tendency to limit RPM to speeds that will likely not result in blown flywheels and connecting rods.

The advice I tend to hand out is- upgrade the springs ONLY AFTER upgrading the 'wheel and rod- not before.

If your next move is exhaust, intake, and tuning, then the really is no point. For the record, trying to re-jet a perfectly stock, governed engine is pretty pointless too, unless your current jet is not right.
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Stock? Make sure fuel flow is not being restricted first. Check tank, lines, shutoff valve, float and float needle, and jet for clogging. Or, it may just be a bit lean because of emissions requirements. If you're planning the intake and exhaust SOON, hold off on rejetting 'till it's done. Why do it twice?
 
Status
Not open for further replies.
Top