twin disscussion

Status
Not open for further replies.

Rotore

Teh SPIK
Messages
1,663
Reaction score
1
Location
Caguas, Puerto Rico
Well i took the heads and the rest of the block off and found a bolt melted in the cyl and is permanantly on the head and yes water did get into the cylinders. It had about an 1" of dirt on it so it did over heat and the rings on one piston melted in the groves so cyl needs to be honed and not sure about the bronz pistón and rods.

But will post piks an a couple mins
 

Kaptain Krunch

Pro Junk Collector
Messages
4,636
Reaction score
4
Location
vermont
I think you should just save up for a motorcycle engine, it'll have more power, a transmission, and wind out high/faster.
 

Rotore

Teh SPIK
Messages
1,663
Reaction score
1
Location
Caguas, Puerto Rico
Lol im broke for now dude im just using the kohler because i got it for free.

 

Rotore

Teh SPIK
Messages
1,663
Reaction score
1
Location
Caguas, Puerto Rico
Well basically the pistons and rings are fired due to an in of dirt on the engine and a bolt on some sort i think fell into the cyl and mated with the head and finally the engine after sitting outside for so long water got in side the cyl
 

Rotore

Teh SPIK
Messages
1,663
Reaction score
1
Location
Caguas, Puerto Rico
Thats what i plan on doing dude i have a spare head to swap out, hone the cylinders and new rings and were set.

Btw would the engine be able to push a 18x9.5" tire with a 4.2:1 ratio or should i go with 11" tires?
 

freakboy

the names 'mater
Messages
3,961
Reaction score
2
Location
hick town
I'll still be burnin the belts and it's gona have good toruqe and If I want more ill put it in a low gear and I forget what ratio ima run to get them speeds.
 
Status
Not open for further replies.
Top