Turboing a 212cc predator

Status
Not open for further replies.

Ebrownie

Member
Messages
582
Reaction score
8
Location
Western Montana
A 150cc dirt bike engine would do very well, better than a predator. Then you also get the gearbox, which is nice to have. But it depends a bit; would you use a 2 or 4 stroke dirt bike engine?
 

Kartorbust

Inmate #627
Messages
4,605
Reaction score
1,101
Location
Utica, NE
I'd get any engine within reason that would work. Most of the take off can be changed with just a gear ratio swap, so even a lower end engine can preform pretty well with deep gearing. But then would you want to do a manual or get one with a CVT and not worry about a clutch setup or shifter linkage?
 

jd8430

jd8430
Messages
8
Reaction score
0
Location
Alabama
I also was reading on one of these threads that you can put a honda gx160 head on my motor and increase the horse. What kind of cheap tricks do y'all do to yours.

---------- Post added at 09:14 AM ---------- Previous post was at 09:10 AM ----------

This forum isn't updating for me. Most dirt bike motors have transmissions on them on eBay. I would rather stay with my predator and not spend the money on a 150cc motor
 

jd8430

jd8430
Messages
8
Reaction score
0
Location
Alabama
What it take to be able to spin lawn mower tires that's what I have. I built this cart from scratch
 

Kartorbust

Inmate #627
Messages
4,605
Reaction score
1,101
Location
Utica, NE
The only cheap mods you can do are, rejet the carburetor (free to $5), k&n style air filter with adapter ($33), straight pipe exhaust ($30+8 for silencer/muffler). All removing the governor would do is free up engine rpm til about 5000 then the valves start to flutter and you won't be going much further. So for about $60 you can go from about 6.5 to about 12hp roughly. I believe the gx160 head only fits on the 60363 (Hemi) engines without much work. If I recall, the 14cc head GX160 brings compression up to about 10:1 maybe more.
 
Status
Not open for further replies.
Top