Torque Converter Swap Out

[Janulispro]

I have a 3/4 bore engine and torque converter. I just swapped the engine to a bigger 8hp engine but the bore is a 1inch bore. Can I just buy the drive clutch pully or do I have to swap out the whole thing?

I would assume I can just get the drive clutch pully since it looks like both the 1 inch and 3/4 inch system look like they use the same pully. Anyone else try this?

 

[Bbqjoe]

I have a 3/4 bore engine and torque converter. I just swapped the engine to a bigger 8hp engine but the bore is a 1inch bore. Can I just buy the drive clutch pully or do I have to swap out the whole thing?

I would assume I can just get the drive clutch pully since it looks like both the 1 inch and 3/4 inch system look like they use the same pully. Anyone else try this?

I'd probably give it a try.
Worst case scenario is you just have to buy a new driven.