torque converter problems. HELP

Status
Not open for further replies.

B man

Tecumseh FTW!
Messages
2,490
Reaction score
3
Location
Oliver springs,Tn
ok so i have a max torque converter. it seems it wants to take off when it idles. and i have tried moving the idle around. it is ruff on the driver and driven. could that cause it to grab the belt?
Because the center distance is correct. they are just a little out of line(not much at all). it appears the ruff surfaces just grab on to the belt.

Need help quick my dads thinking about getting rid of the kart if i dont find out why.
 

B man

Tecumseh FTW!
Messages
2,490
Reaction score
3
Location
Oliver springs,Tn
still wants to pull away though. i can stop it and it will still run,but it still wants to run away without any one on it.

think cleaning the driven would fix that? but it drives great,but at first it was sluggish and wouldn't even attempt to go up a hill. so i stopped it. second time i ran it(and from this point on)it worked fantastic. no hill it wouldn't climb. go fast as a rocket(i think hooking my motor back up i might have accidentally done something to the gov.) but now it preforms great on hills and straights.
 

Blazkowiez

Kart Aficionado
Messages
2,538
Reaction score
48
Location
Houston, Texas
You may need small aircraft washers spacing your driver clutch out if it wants to grab the belt on idle below 2,000 rpm. Do you have access to a tach to tell if it is indeed lower than that speed? The washer must be 3/4" id and an od such that the inner part of the driver clutch can slide over similar to the motion it enters when it runs over the hub to move the belt higher on the angle of the clutch. I hope this made sense, if not i'll try and take a picture of one next to a ruler for you.
 

element10554

New member
Messages
175
Reaction score
0
Location
Glen Mills Pa
You should take measurements from your Driven and Driver units and make sure you have the proper belt. Your belt might be a little to tight and that is why its still grabbing. If you can depending on your setup move the Driver and Driven a bit closer together.
 

B man

Tecumseh FTW!
Messages
2,490
Reaction score
3
Location
Oliver springs,Tn
mxt-98. has to be correct. the others are ethier smaller or way bigger. i know i have to replace the outboard spring on the driven. and the one in the driver is loose and rusty. its only about 17$ to replace them. i still need to clean the driven unit.
 

redsox985

Active member
Messages
4,092
Reaction score
12
Location
PA
If all of the springs aren't in good shape, it will not work properly. TCs are pretty simple things and it takes quite a bit to mess one up beyond repair.
 
Status
Not open for further replies.
Top