Torque Converter issue..........

Status
Not open for further replies.

Joe-405

Enjoying New Projects
Messages
2,673
Reaction score
98
Location
U.S.A.
So first and foremost I am NOT blaming go powersports as this was a one off deal designed by me.


But I do not have a neutral at all. If I put it on a block and start it everything works perfect. But as soon as the back tire stops it kills the engine. Isn't the belt supposed to have more play than this..........

I think when I told them I wanted this other driver it screwed it all up. Does anybody know if the 40 series is smaller or different than the 44 magnum series driver ? I can get belts from my work and order one to have it by next weekend for my car show I'm going to but inwanna make sure. I looked at the 44 and 40 instructions but they don't really say anything.


P.s. It didn't stop me from getting the first test ride in tho !!! Lol
 

Attachments

  • image.jpeg
    image.jpeg
    146.5 KB · Views: 7

Joe-405

Enjoying New Projects
Messages
2,673
Reaction score
98
Location
U.S.A.
Just found the differences. It's 11/64 bigger in diameter than the regular one they make it with. I'm assuming have enough for it not to work correct ? The next belt up is almost a 1" longer and I bet it's too much.


Edit.... Thanks for the help but I think I got it figured out. I will just add another spacer between the driven to make it wider. Then I can keep my 2 belts I already have. And when they stretch I just pull the spacer back out. Whatcha guys think ???

It's circled in the picture
 

Attachments

  • IMG_20160729_224853.jpg
    IMG_20160729_224853.jpg
    66.3 KB · Views: 1

chancer

ɔ ɥ ɐ u ɔ ǝ ɹ
Messages
9,358
Reaction score
97
Location
COMFORT, TEXAS
11/64s bigger is only 1/20th of an inch more in circumference. I am assuming, Should not make that big a difference.
 

KartFab

Active member
Messages
3,381
Reaction score
60
Location
Dallas, TX
Besides looking at center to center you need to check the spacing of the belt from the drive unit. With the 30 series you need at least 1/8" gap? Not sure about 40 series.

Less torque on startup, but that's not really a big deal. If your belt is too short, it could ride up against the crush washers and shred the belt a bit, or it could actually damage the torque converter itself from the stress.

Can't you just re-drill a few holes on the plate to match the center to center that you need?
 

Joe-405

Enjoying New Projects
Messages
2,673
Reaction score
98
Location
U.S.A.
I redrilled the holes. its far enough up i had to clearance the crank. But it works a little bit now might try moving it back to normal and trying the next size up belt
 
Status
Not open for further replies.
Top