torque converter getting hot!

does your TC get too hot to touch?


  • Total voters
    7
Status
Not open for further replies.

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
Hello,

I have a GTC TC2, which is a clone of the comet TAV2, 30 series. unfortunately i do not own a COMET 30 series (of course they are for sale again :mad2:) so i cannot compare between the two.

Anyhow, i have noticed my torque converter gets HOT, i sure wouldn't enjoy holding on to it for a second or two, and that's only after like 20min!

i'm geared for about 38 MPH @ 4000 rpm, with a 6hp engine, in a one seat kart, on the street, going up some minor hills, flooring it most of the way. maybe, its just me, but I don't think i'm asking too much.

if it helps i can also get pictures of the TC, assembled, and/or disassembled as much as you want.

one thing i have noticed is that even uphill it is in the overdrive ratio. i would say that either shows 1) the system is not at all being stressed, but then why does it get so hot? 2) the system is not functioning correctly, maybe bad springs? i have considered buying comet springs, not sure if that would do anything.

also, just recently the speed has dropped off considerably unless i'm going down hill WOT, but up hill and flat ground are wayyyy slower than usual.

if your curious, the belt should be correct (unless GTC gives the wrong belts to you) and is installed correctly. it has lost 1/16" from the top width (that may have something to do with speed, but not the heat problem). if 1/16" is a lot to loose from the belt, this thing eats belts, can't have more than 4-5 hours on it!

soooo, to my questions:

- those of you with comet TC's, does your TC get too hot to touch?
-what would cause a TC to get very hot?


maybe i'm just being stupid, and all TC's get hot just from the belt moving around, but if its not normal i would like to fix it.
 

DCProductions

Cockney Ragamuffin
Messages
496
Reaction score
0
Location
Louisiana, USA
Mine gets hot from the engine and from heavy loads (too hot to touch, but not as hot as my engine). By heavy load I mean stop and go driving or hauling my friend's go kart up a 30 degree incline.

Check to make sure the vertical faces are lined up perfectly. Also when you are climbing hills, let off the gas briefly and floor it again to let the tc slip back into high ratio. Mine sticks in low ratio if I hit a hill too fast. With the way you're geared you should have no problem with any hill. I'm at about 45mph at 4000 and I've never hit a hill I can't climb (6.5hp clone- light mods to around 8hp?)

Edit- With a slightly worn belt, your high ratio will not be as powerful. It shouldn't be that big of a deal though.
 

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
to what degree of hot?

It would not at all be pleasant to touch, but it's not glowing red or anything like that.

Mine gets hot from the engine and from heavy loads (too hot to touch, but not as hot as my engine). By heavy load I mean stop and go driving or hauling my friend's go kart up a 30 degree incline.

Check to make sure the vertical faces are lined up perfectly. Also when you are climbing hills, let off the gas briefly and floor it again to let the tc slip back into high ratio. Mine sticks in low ratio if I hit a hill too fast. With the way you're geared you should have no problem with any hill. I'm at about 45mph at 4000 and I've never hit a hill I can't climb (6.5hp clone- light mods to around 8hp?)

Edit- With a slightly worn belt, your high ratio will not be as powerful. It shouldn't be that big of a deal though.

I don't think its the belt, it was worn down a bit after only a few hours, then hasn't worn much (maybe that's a clue?).

I'll check pulley alignment, its on a back plate though, so unless something bent, it should be fine.

yea, I think I'm geared pretty mellow. single person, no cage, 6HP, TC, top speed of... 35MPH?, on pavement, either full gas, or no gas at all (99% time), and a few inclines.

It's probably not a big deal, it still works fine, just gets very hot (although I did loose some speed, but I think that could be from tightening the chain.)
 

redsox985

Active member
Messages
4,092
Reaction score
12
Location
PA
An infrared thermometer or a candy thermometer capable of high temps would be good so that maybe a few of us could compare and establish a norm.
 

r97

Measure twice cut once
Messages
3,793
Reaction score
9
Location
Massachusetts, USA
best thermometer i'm got is like a cooking thermometer. i do think maybe i have underestimated myself a little bit, i went driving yesturday and found my self screwing with the throttle a lot more than i remember, that might be the problem. but i still lost a lot of speed, but i'm thinking that might be caused by a problem further into my drive line.

can't wait till' i have the time and money to get the racing frame built, it will be so much better. the ride i just went on, at one point the wheels had zero traction and i had to slam on the brakes which just barely work.
 
Status
Not open for further replies.
Top