Torque Converter gear ratio

Status
Not open for further replies.

lowalk

New member
Messages
8
Reaction score
0
This might be somewhat of a noob question but:

I'm planning on getting a 30 series torque converter that comes with a 10T sprocket. Now I know for centrifugal clutches there should be a gear ratio of at least 6:1, does this apply the same to TCs? Or could I have a 48 tooth sprocket on the axle to the 10T on the torque converter? (4.8:1 ratio)

Cheers, Luke
 

landuse

Moderator
Staff member
Messages
18,804
Reaction score
613
Location
Pietermaritzburg, South Africa
Welcome to the forum Luke. With a TC you can generally gear a little higher than a cent clutch. Some people gear to 5:1 or 4.5:1.

Wait for some more people to chip in as well though. I am not the expert
 
Status
Not open for further replies.
Top