r_chez_08
Should be in the shop...
Hi,
I have an adapter to fit a comet 40 1" I/d driver to a 3/4" shaft.
The adapter protrudes by approx. .020. Therefore when the driver is bolted down tight, there is approx. .020 play.
I have heard that centrifugal clutches should be allowed to move very slightly on the shaft. Does this apply to my torque converter, or should I grind a little from the end of the adapter so that the torque converter is bolted up tight?
Cheers
Rob
I have an adapter to fit a comet 40 1" I/d driver to a 3/4" shaft.
The adapter protrudes by approx. .020. Therefore when the driver is bolted down tight, there is approx. .020 play.
I have heard that centrifugal clutches should be allowed to move very slightly on the shaft. Does this apply to my torque converter, or should I grind a little from the end of the adapter so that the torque converter is bolted up tight?
Cheers
Rob