Tires and wheels

Status
Not open for further replies.

OzFab

Well-known member
Messages
15,615
Reaction score
76
Location
Warwick Qld, Australia
Personally, I think it would look better with bigger wheels. However, by putting bigger wheels on, first you have to find some that work with your current setup & it doesn't end up overgeared, plus bigger tyres are usually more expensive.

Considering all of that, you're probably better off sticking with what you have; unless you're looking for a summer project
 

landuse

Moderator
Staff member
Messages
18,804
Reaction score
613
Location
Pietermaritzburg, South Africa
Posted in the engines section by mistake:

Hi Folks
Broke out the Kart yesterday and found that it needs new tires for sure.
Now it has 4.10/3.50-4 tires on it. Can I use a taller tire? Do I have to replace the rims to do so? Where is a good place to get tires/rims?
Thanks!
Sid

http://www.diygokarts.com/vb/attachment.php?attachmentid=15679&d=1315225460

I don't know where you can get new tyres and rims, but just keep in mind that if you change up more than about 10% of the size that you have at the moment, then your gearing might likely be a bit off. Post your clutch and axle sprocket tooth counts, and we can see what you have
 

dmaznic

dmaznic
Messages
46
Reaction score
0
Location
Toronto
where do you get 10% from? any change to the driven wheel sizes will affect the gearing (in this case reduce acceleration but possible higher top speed)
 

souperman000

New member
Messages
2,466
Reaction score
11
Location
Westlake Village, CA
where do you get 10% from? any change to the driven wheel sizes will affect the gearing (in this case reduce acceleration but possible higher top speed)

the 10% is kind of a "margin of error". Yes any change in tire size will effect gearing, but only 10% wont make much of a difference. For less than 10% change, changing the gearing is to much work, you wont notice that much change anyway.
 

landuse

Moderator
Staff member
Messages
18,804
Reaction score
613
Location
Pietermaritzburg, South Africa
where do you get 10% from? any change to the driven wheel sizes will affect the gearing (in this case reduce acceleration but possible higher top speed)

the 10% is kind of a "margin of error". Yes any change in tire size will effect gearing, but only 10% wont make much of a difference. For less than 10% change, changing the gearing is to much work, you wont notice that much change anyway.

What he said. Changing gearing for such a small change is not worth it, and your gearing won't be off enough to make a difference.

It is just a 'rule of thumb'
 

dmaznic

dmaznic
Messages
46
Reaction score
0
Location
Toronto
I would agree that for initial build, it's not worth it. But gearing is one of the fastest way to tune it. Think of 28 speed bicycles that make maybe 0.5km/h difference between gears.

Here is the formula for you to decide:
pi*60*RPM*(d_new-d_old)
for a 5% increase in your wheel diameter with axle at 2000rpm, you go from 39.2km/h to 41.2km/h. That's noticeable! With increasing axle rpm, the change becomes greater.

10% rule of thumb is a strange criteria, use it with caution

some changes are worth it if parts are on a good sale :)
 

landuse

Moderator
Staff member
Messages
18,804
Reaction score
613
Location
Pietermaritzburg, South Africa
10% rule of thumb is a strange criteria, use it with caution

dmaznic, I don't think you understand what we are trying to say here. If you change your tyre size by approx. more than 10%, you are going to have to regear otherwise you are going to be going nowhere, and burning up clutches.

There is no argument on the fact that no matter what you do to your tyres there is going to be a speed difference. That is logical, and is not up for debate. What is up for debate is the practicality of changing tyre diameter and not having a look at your gearing. If you get bigger tyres, then YES, you will go faster, because you have essentially geared your kart lower. That DOES NOT mean that you will PRACTICALLY be able to ride your kart without a few problems. You will be burning out your clutch a he// of a lot faster, and will probably not be able to make it up to that theoretical speed that the speed calculator gives you.

You have got to think about real world conditions. One thing you have got to think about when giving advice, is that someone might actually take it. That is why you have got to be sure of what you are saying.
 

dmaznic

dmaznic
Messages
46
Reaction score
0
Location
Toronto
Sorry, I agree, I'm just not a fan for "rule of thumb". See if the gearing was already very low for a given engine/clutch, increasing tyre diameter by even 30% MIGHT not do any harm. On the other had, it may already be burning the clutch! We just don't know. I stick by saying that the best advice is founded on some principal. The individual then needs to gather such advice and make their own decision.

On the practical note, yes there is always something we can't foresee. Funny example with the tyre diameters is that they could vary by up to 20% with some ATV tyres simply by changing the air pressure! Moreover, the bigger tyres will tend to sag more when load is applied on them so effective diameter changes again.

So basically three approaches:
1. ignorance is bliss
2. experiment with what you have
3. spend lots time and money fine tuning to find the perfect balance between theory and practicallity (then repeat for any new track/course you ride on)

personally, I don't like #3 because it takes away all my summer days :)
 
Status
Not open for further replies.
Top