Timing on a Briggs

Status
Not open for further replies.

Clayton

New member
Messages
294
Reaction score
0
Location
Saskatchewan, Canada
I have just converted a vertical shaft Briggs to a horizontal shaft. I was watching a video about it, when the guy said something about lining up a couple dots to get the correct timing. Could anyone tell me how to do this, or even hav a pic of this done right? :huh:
 

karl

Well-known member
Messages
2,449
Reaction score
719
Location
North east Ohio
That picture isent the exact same as your engine but you will get the idea. You need to make sure the dots line up once everytime you rotate it.
 

Attachments

  • timing.bmp
    98.8 KB · Views: 7

Clayton

New member
Messages
294
Reaction score
0
Location
Saskatchewan, Canada
Yeah, I opened her back up and on the crank, on one of the teeth there is a line, and on the cam there is a dot, so I linked them up. The motor still wont start! but that's because that little square shaft kinda peice on the flywheel is worn and doesn't catch when I pull the recoil! Anybody know how to fix that? I thought I might just build it up with a welder, then grind it to fit.
 
Status
Not open for further replies.
Top