timing key ?

Status
Not open for further replies.

pearl111

Well-known member
Messages
1,166
Reaction score
434
Location
Baltimore, Maryland
Hello I will upgrade my predator 212 hemi with air intake gas jet exhaust header, since I took the governor out. I don't under stand and I am not sure if I need the 8* timing key. Do I need to change to an 8* key if so can someone tell me. I don't know where it goes but if I have the wright instructions I am sure I can do this as I learned to take the governor out by online instructions. If I need to can someone direct me to the website instructions. Thanks for any help. mike
 

bob58o

SuckSqueezeBangBlow
Messages
9,646
Reaction score
1,866
Location
Chicago-town USA
Do I need to change to an 8* key if so can someone tell me.

No, but it might help higher RPM HP (might hurt lower RPM Torque)
A 4* or 6* key might be better? Some say that didn't notice a difference.



]I don't know where it goes

You have to take the flywheel off the crank shaft.
The crank is keyed and a woodruff key holds the flywheel in place in relation to the crankshaft while the nut is torqued. An 8* key is offset so the relation of the flywheel and crank is rotated a few degrees. This changes when the spark plug fires due to the positioning of the magnets on the flywheel. When looking at the crank shaft from the flywheel side, the key gets installed so that the flywheel is allowed to rotate a bit more in the clockwise direction.



but if I have the RIGHT instructions I am sure I can do this as I learned to take the governor out by online instructions. If I need to can someone direct me to the website instructions.


https://www.affordablegokarts.com/advance-timing-install-aluminum-flywheel.php
 
Status
Not open for further replies.
Top