Throttle hookup

[TheBeaves26]

I have a briggs and I have no idea how to hook up the throttle. Any help is appreciated

 

[J.S.@SMS]

What you have to do is get one of the throttle cable housing clamps from something like a predator (the thing that looks a bit like a C, and has a screw going through it). Install it in the threaded hole with the notch above it (not the one the spring's hooked to, the other one). Use that clamp to hold the cable housing, and thread the throttle cable through the hole on the throttle arm. Then use a barrel clamp (also found on predator, honda, etc. throttles) to hold the throttle to the arm (feed the throttle cable through the hole from the top, and put the barrel clamp in the bottom of the arm).

Also, it looks like the spring fell off the throttle arm. You want the setup to look something kile this. And use a pair of needle nose pliers to take off the kill switch, remove the wire and put a bullet connector on it, and run your kill switch to that.

 

[TheBeaves26]

How do you mean?
And yes I know that's off. I was taking the plate on and off