whaleit
New member
Shown on Harbor Freight Engine.
The KIT purchased from AGK worked...but as posted in Dec 2009...."The kit "throttle lever arm" was about 3/16" too long...I had to shorten it and now the "butterfly" closes as should and actually allows the idle screw to do its job."
It came too long and by not allowing the throttle to close it was always reving too high.
Jemo....hope that your problem is similar and you get it fixed...good luck!
The KIT purchased from AGK worked...but as posted in Dec 2009...."The kit "throttle lever arm" was about 3/16" too long...I had to shorten it and now the "butterfly" closes as should and actually allows the idle screw to do its job."
It came too long and by not allowing the throttle to close it was always reving too high.
Jemo....hope that your problem is similar and you get it fixed...good luck!
Attachments
-
Throt_001.JPG -
Throt_002.JPG -
Throt_003.jpg -
Throt_004.jpg