Throttle arm stop screw?

Status
Not open for further replies.

Badot

New member
Messages
677
Reaction score
2
The engine I'm asking about in particular is a HF 6.5. I was wondering about the springloaded screw on the throttle mounting plate that stops the throttle arm at the max setting (as determined by the screw) I'm not too familiar with carbureted or small engines, and I had googled, but hadn't found any results... maybe I'm calling it the wrong thing?

Anyways, I was just curious as to why this exists, save for limiting the potential power of the engine - does this have to be precisely adjusted for maximum power, or can I just toss the screw altogether? Will allowing the arm to travel further than where it came out of the box even increase the power at all?

If anyone could shed some light on this, I'd appreciate it. I'm just trying to learn a bit more about tuning/maintaining the thing pushing me around.
 
Status
Not open for further replies.
Top