tecumseh recoil spring.

Status
Not open for further replies.

Bluethunder3320

New member
Messages
5,677
Reaction score
39
your spring broke? if there are bolts around the pull start housing take them off. if not take the blower housing off. then remove the bolt in the center, pull up the recoil wheel, and your spring should come out pretty fast so watch your eyes!
 

redsox985

Active member
Messages
4,092
Reaction score
12
Location
PA
Relax, B man. It was 1-2 AM here when you posted them. Honestly, from what I can see, that's a very dark photo and I'm not sure. Does the spring provide no pulling resistance?
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
Can't see squat in the pic. Look for a snapring or something. Also, flip it over- maybe it's retained from the outside. If there's a label on the outside, feel around the center with your finger- might be a screw under it.
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
both of the tecumseh's i have (H60 and MH80) have 3/8" bolts in the center. thats strange..... ive never seen a recoil with no bolt on the inside, even my clones.
 

B man

Tecumseh FTW!
Messages
2,490
Reaction score
3
Location
Oliver springs,Tn
1. After removing the rewind assembly from the
engine blower housing, release the tension on
the rewind spring. Remove the starter handle
and carefully allow the rope to unwind into the
starter housing (diag. 4).
2. Remove the decal or plastic disc in the center
of the rewind.
3. Place a 1" (25.4 mm) deep well socket under
the retainer. Set the rewind on a bench,
supported on the socket.
4. Use a 5/16" (7.937 mm) or a [1/4" (6.35 mm)
punch for stamped steel] roll pin punch to drive
out the center pin. The stamped steel center
pin is driven out from the outside, the punch tip
must be angled inside the center hole. Move
the punch around while driving the pin to help
keep the pin straight.





can you explain this plz.
 
Status
Not open for further replies.
Top