Probably tinned brass. I've seen 'em too.
Russ2251 AZUSA:Powered by LAWN-BOY Messages 6,622 Reaction score 47 Location Huntington Station, Long Island, NY Jul 5, 2011 #21 Probably tinned brass. I've seen 'em too.
B man Tecumseh FTW! Messages 2,490 Reaction score 3 Location Oliver springs,Tn Jul 5, 2011 #22 that would explain it then.
Bluethunder3320 New member Messages 5,677 Reaction score 39 Jul 5, 2011 #23 some floats ive seen are brass and silver in the middle where the halfs are joined together. soldered? could kendel have soldered the hole up?
some floats ive seen are brass and silver in the middle where the halfs are joined together. soldered? could kendel have soldered the hole up?
Russ2251 AZUSA:Powered by LAWN-BOY Messages 6,622 Reaction score 47 Location Huntington Station, Long Island, NY Jul 5, 2011 #24 Yes, soldered. could kendel have soldered the hole up? Click to expand... Depends on how good he is. I know I cannot.
Yes, soldered. could kendel have soldered the hole up? Click to expand... Depends on how good he is. I know I cannot.
kendelrk redneck engineer Messages 2,425 Reaction score 9 Location westland michigan Jul 5, 2011 #25 i probablly could of, i thought about it, but i already soldered one hole, and the second one was soldered by him and now then there was a third hole so i just said, new float
i probablly could of, i thought about it, but i already soldered one hole, and the second one was soldered by him and now then there was a third hole so i just said, new float
kendelrk redneck engineer Messages 2,425 Reaction score 9 Location westland michigan Jul 6, 2011 #26 well looks like the float isint working, the engine still wont idle
Doc Sprocket ********* Messages 15,677 Reaction score 153 Location Ontario, Canada Jul 6, 2011 #27 Has the float height been set to spec? This is a NEW float, right?
kendelrk redneck engineer Messages 2,425 Reaction score 9 Location westland michigan Jul 6, 2011 #28 brand new float
Bluethunder3320 New member Messages 5,677 Reaction score 39 Jul 6, 2011 #29 its plastic, so you cant set it, am i right?
kendelrk redneck engineer Messages 2,425 Reaction score 9 Location westland michigan Jul 6, 2011 #30 it has the metal tab
devino246 Official DIYGK Chem Nerd Messages 3,856 Reaction score 17 Location Lynchburg, VA Jul 6, 2011 #31 Bluethunder3320 said: its plastic, so you cant set it, am i right? Click to expand... Should be a metal connector, which you bend to set the height.
Bluethunder3320 said: its plastic, so you cant set it, am i right? Click to expand... Should be a metal connector, which you bend to set the height.
kendelrk redneck engineer Messages 2,425 Reaction score 9 Location westland michigan Jul 6, 2011 #32 yeah and on the mtel connector sits the needles small sideways L ish type peice of metal