Tecumseh 6hp help!!!!

Status
Not open for further replies.

forsfed86

New member
Messages
2
Reaction score
0
Ok I bought a used Carter Brothers kart for my son as a Christmas gift and I'm having some issue with it. It's a OHH60 6hp Tecumseh engine. It has been cranking fine but if you push the gas it boggs down and will die. If you give it gas and immediately let off of the throttle the engine will rev up and idle fine but as soon as you give it gas again it tries to die. I've replaced the spark plug and I removed and cleaned the carb, it was clean when I got it apart. Still does it if you remove the gas cap. I thought it may be clogged or defective. Also does it with the air filter removed. After a long warm up period it still does the same thing. Any ideas or help will be greatly appreciated.

Allen :mad2:
 

Bluethunder3320

New member
Messages
5,677
Reaction score
39
id say it is too lean.

there is a mixture screw on the carb. turn it in and less gas, out more gas.

lean=too little fuel
rich=too much fuel

if that doesnt work then check the carb gasket, you can make one from a cereal box.

are the fuel lines in-tact?

good luck, try those few tips, and btw, put up some pics if possible.

P.S. welcome to the forum!
 

Blazkowiez

Kart Aficionado
Messages
2,538
Reaction score
48
Location
Houston, Texas
id say it is too lean.

there is a mixture screw on the carb. turn it in and less gas, out more gas.

lean=too little fuel
rich=too much fuel

if that doesnt work then check the carb gasket, you can make one from a cereal box.

are the fuel lines in-tact?

good luck, try those few tips, and btw, put up some pics if possible.

P.S. welcome to the forum!

Could you please show us a picture of the mixture screw on a stock go-kart ready Tecumseh engine?

The screw many people mistake for a mixture screw is really an idle restriction screw, this sits firmly in place and is not adjustable on the newer engines. On many older (side valve) Tecumseh engines they had 2 adjustment screws but the newer (overhead valve) versions never have, not for karting purposes. You could perhaps thank the EPA for this but mainly its just evolution to being more user friendly.

It just sounds like your 2 jets are still clogged on the carb.
 

forsfed86

New member
Messages
2
Reaction score
0
Thanks for the responses guys I will try out what was suggested and let you know the results. I will also try and get some pics up!

Thanks again.
 
Status
Not open for further replies.
Top