tapered to straight swap

Status
Not open for further replies.

ML-TOYS

New member
Messages
2,908
Reaction score
21
Location
long island, new york
its been over 30 years since i rebuilt one of these 5hp motors.
i have a b&s motor that i want to change the crankshaft in.
besides the obvious crank what other parts are needed ?
i dont remember if there are rod bearings or crank bearings.

tips on how to get the correct crank too.
any help would be appreciated
 

klicky96

New member
Messages
558
Reaction score
1
Location
Sandusky, Ohio
If the crank is from the same horsepower engine, then all you should need is the crankshaft. The bearings should be the same, but if one of them are different, it would probably be the crank bearing.
 

r_chez_08

Should be in the shop...
Messages
4,827
Reaction score
14
Location
Cornwall, UK
Nothing else is required, however it may be an idea to replace piston rings if they are worn, and possibly the connecting rod. If the bearings (if bearing block) are worn, replace them too.
It is worth spending a little to replace anything that is 'just ok' whilst you are inside the motor.

Oh and you need a new side cover gasket.

The rod doesn't have bearings as stock, only the arc rods have bearing inserts.
 

Brandon1023

needs an oil change
Messages
422
Reaction score
4
Location
Miami, Florida, Dade County 305
I agree with r chez. Since you'll have the oil already drained as well as the side cover removed, that'd be a good time for new rings while you're already in there. I'd go with the rebuild since people like me actually find fun in taking apart a motor and putting it back together. lol.
 

Brandon1023

needs an oil change
Messages
422
Reaction score
4
Location
Miami, Florida, Dade County 305
Yes, tearing apart an engine and spinning things by hand is the best way to see all the parts in motion and learn all about the internals. Sounds like you have experience in that, but when I just started getting an interest in small engines, tearing apart a 5hp tecumseh engine was the best lesson I ever schooled myself with.
 
Status
Not open for further replies.
Top