I bought a yerf dog kart used from a buddy of mine for my kids to ride. I bought a new speing and 6 new insert buttons for the t/c. We've been able to ride the kart a few times without any issues. Went to ride yesterday and noticed that it was running fairly slow. Looked back i noticed that the belt was only half way up the driver and not moving any further (throttle all the way open). Stopped the kart and noticed that the "peaks" of the driven unit were sitting in between the insert buttons. Dont know if this this is worn out or what. Ant ideas? Thanks.
T/C issues
- Thread starter RazorMMA
- Start date
- Status
Cjhoward78
New member
- Messages
- 112
- Reaction score
- 0
Did u preload the spring on the driven when u reassembled it?
I did. Unless i did it wrong. Read online its about a quarter turn, to the first button. Clockwise i believe. "Tightening/loading" the spring? Cant remember off the top of my head which way without lookimg at it. I'm going to pull it off tomorrow and take a couple of pictures.
Cjhoward78
New member
- Messages
- 112
- Reaction score
- 0
If done correctly u would turn clockwise tensioning the spring past the first button then press completely onto shaft and apply c-clip. The out sheave should then have spring tension against the button.
- Status