Straight Pipe On A Dirtbike Engine?

Status
Not open for further replies.

spudkilla224

New member
Messages
115
Reaction score
0
Hello everyone, I am about 2 aquire a 4 stroke Honda 1981 XR250R dirtbike engine, would it be ok to run a straight pipe from the block of the engine? If so would I loose performance with no back pressure? Also do dirtbike engines need back pressure? Also how loud would it be? :thumbsup:
 

Kenny_McCormic

Kartless....
Messages
4,537
Reaction score
11
Location
Michigan Troll
On a 4 stroke it will be fine, it will be loud. Back pressure is wildly misunderstood by many, including yourself. To my understanding you only want it in a 2 stroke, this animation shows back pressure in a 2 stroke.

You don't need that in a 4 stroke.
 

Rickracer

RM250 Race Kart Driver
Messages
673
Reaction score
2
Location
Kissimmee Fl.
That's not backpressure Kenny, it's a reversion pressure wave, ;)
Backpressure is NOT desired, ever, although proper pipe sizing is important, for pulse tuning/scavenging, when you get it right, it can be worth as much as a 5 to 20 percent increase in power, ;) :cool:
 

Kenny_McCormic

Kartless....
Messages
4,537
Reaction score
11
Location
Michigan Troll
That's not backpressure Kenny, it's a reversion pressure wave, ;)
Backpressure is NOT desired, ever, although proper pipe sizing is important, for pulse tuning/scavenging, when you get it right, it can be worth as much as a 5 to 20 percent increase in power, ;) :cool:

Well if you wanna get all scientific and ****, yea.
 

Russ2251

AZUSA:Powered by LAWN-BOY
Messages
6,622
Reaction score
47
Location
Huntington Station, Long Island, NY
As soon as anything is added to exhaust port...there is back pressure.
Be it a straight pipe, muffler, expansion chamber, megaphone, or a finger.
It's been argued that a 4 cycle engine requires back pressure for increased life expectancy. Pure B.S.!!!
By the time any valves are hurt by a lack of back pressure...engine will be worn out any way.
I'm a straight pipe guy. Count on at least a .5 hp increase on a 4 cycle engine. More on a 2 cycle.
 

jr dragster T

New member
Messages
3,966
Reaction score
10
Location
Cold place
Better hope you have the exhaust manifold for that XR250R because its a 4 valve motor with 2 exhaust ports. Making a manifold for that would take some time and skills.
 

modelengineer

Lord of the noise
Messages
1,609
Reaction score
2
Location
Sydney, Australia
Or run 2 straight pipes...

e.g on my twin there is no manifold, just two exhaust clamps.

You will most likely need to re-jet the carbs or it will run lean, which could lead to overheating or melting a piston.
 
Status
Not open for further replies.
Top