Sprocket size?

Status
Not open for further replies.

cockerhambw

New member
Messages
14
Reaction score
2
Location
Louisiana
Ok next step, I have a 10hp B&S, with 12 tooth cent. clutch, 18.5 x 9.5-8 tires and the TCW of cart will be about 350 - 400lbs, what size sprocket should i get, and should i be using a jack shaft or not? oh and will be used off road mostly:drool5:
 

Doc Sprocket

*********
Messages
15,677
Reaction score
153
Location
Ontario, Canada
I would not consider that a particularly workable combination if you want any kind of performance at all. 10hp, big tires, heavy kart, centrifugal clutch. If you're not concerned about speed, start gathering jackshaft parts. If you are, time to go shopping for a CVT.
 

redsox985

Active member
Messages
4,092
Reaction score
12
Location
PA
Or even a bike style/snowmobile engine! A CVT (TC) will be good, but either of the two previous will preform very well. What kind of offroading? Like fields and dirt or quad trails?
 

cockerhambw

New member
Messages
14
Reaction score
2
Location
Louisiana
this thing used to have a 6hp with a 34 tooth sprocket, dont know what size clutch, but by looking at manual it did have a jack shaft, i made some minor mods to it, to extend it and change the height and bigger shocks, the cart itself weighs maybe 150, its an old murray hard drive. wasnt looking to spend to much money on it, and a cvt looks to be a bit pricey for this cart. i havent bought the tires yet, so those could be changed.
 

Attachments

  • SDC11149.jpg
    SDC11149.jpg
    119.1 KB · Views: 8

redsox985

Active member
Messages
4,092
Reaction score
12
Location
PA
It may need to be beefed up to support it, but it will be a much more satisfying engine.
 

cockerhambw

New member
Messages
14
Reaction score
2
Location
Louisiana
ok going with the 230, framing up this weekend will post pics when finished, bought some square tubing today, wish me luck
 

redsox985

Active member
Messages
4,092
Reaction score
12
Location
PA
Will the motor be on the swing arm? Are you going to use the bolts under the motor to bolt it down or will you make some type of cradle for it? I would hard mount it and then use a chain tensioner if it was on the swing arm to make sure it stays tight although there shouldn't be issues. It won't be hard to fab up and will pay off.
 
Status
Not open for further replies.
Top